Sprinklers have always been among the most demanding models in Sanitation vehicles. Their sales over the years have also ranked first among the sales of special vehicles. Before users purchase water trucks, it is necessary to understand the specific operation methods of the vehicles and follow them. Edit the lens to master:
Before understanding the actual operation method, we must first understand the overall structure of the car. The sprinkler is composed of a special type II chassis, power take-off devices, self-priming sprinkler pumps, tanks, spraying devices, working platforms and other basic components.
Suction work
First, remove the standard water-absorbing rubber hose and put it in a little order. Connect one end to the water inlet without bending.
The other end is placed in the sink so that the end of the tube is not always in the pool, to avoid inhaling air or debris;
Next, find the four-way valve. Push the valve perpendicular to the ground through the handle and open the water inlet. Then, the cab will hang the transmission into neutral, start the engine, loosen the clutch, and pull the power take-off switch backwards. Bit. Self-priming sprinkler pumps began to work and began to work on suction.
After full irrigation, close the power taker and return the above operation in turn.
Spraying operation
First, the four-way valve handle is pulled parallel to the ground, the water outlet is opened, and then the sprayed ball valve is opened. Here, there are components such as forward punch, back spray, side spray, shower head, etc., which start the engine, loose the clutch and take it. The power switch is pulled backwards and engaged in the gear. The self-priming sprinkler starts to work and begins to sprinkling.
The above is the specific operation methods of the sprinkler water suction operation and spraying operation. If there is any doubt, you can consult online special steam network customer service and sincerely answer your questions.
The forging process over the recrystallization temperature of metal is called hot forging.Hot forging is also called hot die forging. During forging, the deformation metal flows violently and the Forging Parts contact with the mold for a long time.Therefore, it is required that the mould material has high thermal stability, high temperature strength and hardness, impact toughness, heat resistance fatigue and abrasion resistance and is easy to process.The thermal forging die with lighter working load can be made of low alloy steel.
Hot Forging Parts
YaoPeng Metal Products Co., Ltd. , https://www.ypmfg.com