The use of digital display multi-functional stirrer maintenance:
1. Turn on the external power supply, close the power switch, and the indicator lights up.
2. Magnetic stirring:
1 Place the test bottle (or other vessel) containing the solution and stirrer on the top plate of the work surface.
2 magnetic stirring switch, the corresponding indicator light.
3 Adjust the "Magnetic" speed control knob to the desired speed and the corresponding indicator lights.
3. Electric stirring:
1 Determine the mounting or placement of the filling test bottle (or other vessel).
2 Adjust and calibrate the position and height of the motor and clamp on the column.
3 clamps.
4 open electric stirring switch, corresponding indicator light.
5 Adjust the "electric" speed control knob to the desired speed and the corresponding indicator lights.
4. Heating temperature:
1 Turn the temperature “SET-TEMPERATURE†selection switch to “SETTINGâ€, adjust the temperature control knob, and digitally display the desired setting temperature.
2 Turn the “Set-Temperature†selection switch to “Measure Temperature†and the digital display shows the actual temperature in the solution. (The red indicator light indicates that the heater is working)
5. After the work is completed, the speed control knob is placed in the minimum position, the temperature control knob is placed in the non-operating state, the stirring switch and the power switch are turned off, and the power is cut off.
6. Wipe the column, work surface, fixtures and sensors cleanly, and do not allow water droplets and dirt to remain on it.
1. Turn on the external power supply, close the power switch, and the indicator lights up.
2. Magnetic stirring:
1 Place the test bottle (or other vessel) containing the solution and stirrer on the top plate of the work surface.
2 magnetic stirring switch, the corresponding indicator light.
3 Adjust the "Magnetic" speed control knob to the desired speed and the corresponding indicator lights.
3. Electric stirring:
1 Determine the mounting or placement of the filling test bottle (or other vessel).
2 Adjust and calibrate the position and height of the motor and clamp on the column.
3 clamps.
4 open electric stirring switch, corresponding indicator light.
5 Adjust the "electric" speed control knob to the desired speed and the corresponding indicator lights.
4. Heating temperature:
1 Turn the temperature “SET-TEMPERATURE†selection switch to “SETTINGâ€, adjust the temperature control knob, and digitally display the desired setting temperature.
2 Turn the “Set-Temperature†selection switch to “Measure Temperature†and the digital display shows the actual temperature in the solution. (The red indicator light indicates that the heater is working)
5. After the work is completed, the speed control knob is placed in the minimum position, the temperature control knob is placed in the non-operating state, the stirring switch and the power switch are turned off, and the power is cut off.
6. Wipe the column, work surface, fixtures and sensors cleanly, and do not allow water droplets and dirt to remain on it.
Tungsten carbide lithium
battery cutting blade can be found from from us. They are used for slitting
lithium battery chip. Ultra-fine tungsten carbide particles are used for these
circular blades and allows them to slit lithium iron phosphate, lithium
manganese oxide, and cobalt acid. Our blades are suitable for Areconn,
NISHIMURA, Qianlima, and Dali brands.
Lithium Battery Cutting Blade,Lithium Battery Slitting Blade Knife,Cutting Knife For Lithium Battery
Zhengtong Special Material Factory Hi&New Tech Zone Chengdu , http://www.ztferre.com