Replace to Refrigeration Air Dryer----Biteman Heat Modular Desiccant Air Dryer

BITEMAN Modular units heated desiccant air dryer

Innovative structure with patents,employs small desiccant chamber unit

1.Air flow equally and evenly pass through each desiccant chamber
2.Avoid channelling effect which more likely happens in traditional desiccant dryer
3.Small chamber allow no mandatory annul inspection
4.Molecular sieve capability is much better than Alumina and silicon desiccant in traditional dryer
5.PLC controller ,Full function touch panel control

Structure and operation

Biteman dryer have two groups of desiccant chambers,A and B ,according to flow rate,A and B shift between adsorption and regeneration





Ease of replacement of desiccant chambers,it can't be more simpler comparing to exchange of desiccant,only one wrench it is done.Further more,needn't worry the desiccant density after refilling because it is filled in our factory to keep constant and stable pressure dew point,just like new dryer from factory



Technical data
A-series       Heatless           (-40ºC dew point) Marks
Standard working condition:Inlet pressure 0.7MPa≤P<1.0MPa,Temperature T≤35ºC;
Working condition:Pressure 0.4MPa≤P<1.0MPa,Temperature 2ºC≤T≤40ºC;
Technical date:Pressure dew point≤-40ºC
         Purge air≤ 5%
            Pressure drop≤0.012MP
         Noise≤75dB(average);
 
A-series         Heat                (-40ºC dew point) Marks
Standard working condition:Inlet pressure 0.7MPa≤P<1.0MPa,Temperature T≤35ºC;
Working condition:Pressure 0.4MPa≤P<1.0MPa,Temperature 2ºC≤T≤40ºC;
Technical date:Pressure dew point≤-40ºC
         Purge air: ≤2%
         Pressure drop≤0.012MP
         Noise≤75dB(average);